GRAINGER 13R528 Chest, 48 x 48 x 34.25 Inch Size, 25.25 cu.ft., Tan, Steel

This chest measures 30 inch (H) x 48 inch (W) and is used to store power tools. This unit comes with a full-length piano hinge that is stacked and welded for protection against theft.

Features:

• It has a lock system with a 7-gauge reinforced lock and a 3-point latch to reduce the risk of break-ins.
• This unit features heavy-duty, powder-coated, 16-gauge steel construction with fully arc-welded seams to resist corrosion.
• It comes with an adjustable dampening spring that allows the unit to open from all three sides.
• This chest is integrated with 4-way pre-punched skids to provide access from any side for safe transport and easy installation of optional casters.
• It is equipped with recessed side handles to offer superior mobility and damage protection.
• This chest has a tool gang box having an electrical pass-thru grommet for weather-proof access to a power cord.

Frequently Asked Questions:

Q. How to install a grommet?

A.

• Find the knockout.
• Punch out the knockout from the inside of the box with a screwdriver and hammer so that the metal ring falls outside the box.
• Make sure that the rubber grommet from the outside of the box is properly seated in the hole.
• Pass the cords inside from the back of the box. Pull the cord head back 2 to 3 inches after it is in place to ensure the weather-resistant 'star bursts' are facing the outside of the box.
• Never expose mating plug points to the environment by pushing the cord from inside the box.

Q. What electrical safety precautions must one take during the installation of the grommet?

A.

• Inserting an extension cord through the hole without a grommet is not recommended.
• Use only three-wire extension cords with all three prongs intact.
• Remove the round grounding prong.
• The extension cord must be connected to a grounded 120V GFCI protected outlet. If a GFCI outlet is not available, use an extension cord with built-in GFCI protection.
• Before using an extension cord, inspect the insulation and plugs. If the cord is worn or damaged, do not use it.
• Before moving or transporting the storage chest, remove the extension cord from the Power Pass hole.

Q. How do you install the lock system?

A.

• Using a 1/2-inch socket or wrench, remove the padlock tab.
• Set the latch rod to the 'LATCHED' position.
• Install the 5/16 x 3/4 inch carriage bolt into the appropriate hole in the padlock tab, insert the padlock shackle and secure to the lockbox with a locking nut.
• Open the cover and slide the latch rod into the 'OPEN' position before locking the padlock.
• Close the cover and set the latch rod to 'LATCHED'. Lock the padlock and try to open the cover by moving the latch rod to the 'OPEN' position.