Lovejoy 84527105149 horizontal mounting brackets are used with the brand's hydraulic pumps in industrial machinery, boats, ships, tractors and agricultural applications.
Features:
- This mounting bracket has an aluminium alloy body to resist corrosion on exposed surfaces.
- It features a weep hole to drain pump leakages.
- This bracket can be mounted with NEMA C-Face motors in frame sizes 56C to 405TSC for 2 & 4-bolt pump flanges.
- It is equipped with a motor / pump mounting kit, bolts and washers to mount the pump / motor.
Standards and Approvals:
Frequently Asked Questions:
Q. What is the bolt-hole diameter of this bracket?
A. 17/32 inches.
Q. How do I clean and maintain Lovejoy 84527105149 horizontal mounting bracket?
A.
- Disconnect any power source connected to the bracket and allow it to cool down if it has been in use.
- Use a soft, dry cloth to wipe down the surface of the bracket, removing any dust or debris.
- To remove stubborn dirt or grime, dampen a clean cloth with water and wipe it down the surface of the bracket.
- Do not use any harsh chemicals or abrasives as this may damage the surface.
- Check for any signs of wear or damage, cracks or corrosion. If any damage is found, the bracket should be replaced.
- Lubricate any moving parts of the bracket using a silicone-based lubricant or equivalent, ensuring smooth operation and preventing wear and tear.
- Reconnect any power source and test the bracket to ensure it is functioning properly.
- Regularly check the bracket for signs of wear or damage and clean & lubricate it as needed to ensure optimal performance and longevity.
Q. How to install this mounting bracket?
A.
- Remove any dirt or debris from the surface and ensure that it is level.
- Position the bracket on the mounting surface in the desired location.
- Mark the location of the mounting holes on the surface using a marker or pencil.
- Using an appropriate drill bit, drill the holes in the mounting surface at the marked locations.
- Place the bracket onto the mounting surface and align the mounting holes on the bracket with the holes on the mounting surface.
- Insert appropriate screws or bolts through the mounting holes and tighten them with a wrench or socket driver.
- Secure the hydraulic pump to the bracket using appropriate fasteners or clamps.
- Verify that the hydraulic pump is securely mounted and properly aligned with the bracket.
- Double-check that all screws or bolts are tightened to the recommended torque specifications.