Case Material: 304 Stainless Steel , Flow Rate: 10 to 180 SCFH, 4.8 to 85.7 LPM , Inlet Connection: 5/8"-18 RH Internal , Outlet Connection: 5/8"-18 RH Internal , Size: 5 1/4 x 10 x 6 1/4"
Features
- Miller-Smith two gas mixers have painted aluminium cases for structural rigidity and corrosion resistance.
- They offer built-in flow control that eliminates the necessity for other flow control devices while using single-station applications.
- These gas mixers have printed conversion charts guide embedded on the top of the mixer for aiding in the proper use of gases.
Compatible Accessories
- Miller-Smith Single Hose for Inert Gas 7294-1: They are used with argon / nitrogen(30-150-580) regulator only for connecting to pipes.
- Miller-Smith Medium-duty Regulators: These regulators are used to control and maintain the pressure between 0 to 150 psig.
Frequently Asked Questions
What is the required inlet pressure of these Miller-Smith gas mixers?
They have an inlet pressure ranging from 105 to 115 psig.
What is the filtration level of these equipment gas mixers?
They are equipped with inlet filters of 60 microns nominal (mixer protection only) for reduced contamination.
How to use these Miller-Smith gas mixers?
- Attach the gas mixer to your gas supply using appropriate fittings.
- Set the desired gas mixture ratio by adjusting the mixing valves on the gas mixer. Make sure to refer to the manufacturer's instructions to determine the appropriate settings for your specific application.
- Connect the gas mixer to your welding or cutting torch using the appropriate hoses and fittings.
- Turn on the gas supply and ignite the torch.
- Adjust the gas mixer as needed to achieve the desired flame characteristics, such as flame size, temperature and colour.
- When finished, turn off the gas supply and allow the torch and gas mixer to cool before storing.
Change Country
A
B
C