HARTELL GPP-1MH-1P Ice Machine Pump, 115V, 5/8 Inch Discharge Outside Dia.

Hartell Ice machine pump is designed to fit commercial ice-making equipment, such as Ice-O-Matic / MileHigh ice machine.

Features:

• Hartell GPP-1MH-1P ice machine pump has a dual ball bearing system for high speeds and low friction.
• It has a stainless steel shaft to prevent contamination and protect critical moving components.
• This pump features a thermally protected motor to prevent overheating.

Standards and Approvals:

• NSF

Frequently Asked Questions:

Q. How to install this Hartell pump?

A.

• Position and hold the motor with the shaft facing up.
• Place one washer over each motor stud.
• Slide the slinger down the motor shaft to about 1/2-inch from the motor.
• Place bracket (if used) over motor studs.
• Place the housing over motor studs and note the orientation of discharge.
• Place one washer over each motor stud.
• Screw the thumb nuts onto the motor studs. Do not tighten.
• Center the motor shaft in the housing centre hole and tighten the thumb nuts.
• Slide the impeller onto the motor shaft.
• Push and hold down the impeller. Screw the impeller nut into the motor shaft until it touches the impeller.